The Adaptor Leds - Televes 7664 Manuel D'utilisation

ETHERNET-COAXIAL ADAPTOR 128 Mbps
4
Powering connector
To connect the external power supply of 15V/800mA that comes with the product.
5 Master / Slave switch
At the back of the ethernet-coaxial adaptor 128Mbps, you will find this switch that lets you
select the operating mode (master or slave mode).
Remember to take into account that one of the adaptors must be set to master mode and
the rest to slave mode.
2.1.- The LEDs
ETHERNET-COAX ADAPTER ETHERNET-COAX ADAPTER
1
Power
LED (green) will light up when the adaptor is connected to the power supply.
2
Sync Mode
If the adaptor is in master mode, this LED (red) will be switch on permanently, whether
there are adaptors in slave mode or not.
If the adaptor is in slave mode, this LED will only light up when connected to the master
adaptor. Because of this, it is necessary to make sure that this LED is switch on.
3
Coax Link
LED (yellow) that will only flash on and off when data is being transmitted or received.
9
Ref. 7664