Step 1: Setting The Master/Slave Operation Mode - Televes 7664 Manuel D'utilisation

ETHERNET-COAXIAL ADAPTOR 128 Mbps
3- Installing the Ethernet-Coaxial Adaptor 128Mbps
Step 1- Setting the Master/Slave operating mode
To set the data network it is necessary for one of the adaptors to be in master mode; the rest
of the adaptors must be in slave mode.
There is a switch at the back of the adaptor to configure these operating modes.
Master/Slave
switch
Master setting
Important
Only one adapter from the installation can be configured in master mode,
so make sure that there is only one master connected to the coaxial
network.
Mode setting
10
Ref. 7664