Installing The Zephyr Logo After Reversing The Door - Zephyr PRB24C01AS-OD Guide D'utilisation, D'entretien Et D'installation

Installation Instructions
To prevent damaging the door or door gasket, make sure the door is open at least 90-degrees
when pulling shelves out of the rail compartment.
The door opens to a maximum of 135 degrees with a door stop on the bottom hinge preventing
the door from opening further.
If you do not want to install the Zephyr logo, you can plug the two holes with the included grey
decorative nails.

Installing the Zephyr Logo After Reversing the Door

1. Clean the top surface of the door so the adhesive from the Zephyr logo will adhere to the door.
2. Place the logo positioning tool between the two holes on top of the door and align it.
3. Remove the film underneath the logo and place the Zephyr logo on top of the door. Press the logo
firmly, ensuring the logo adheres.
20 PRB24C01AS-OD Use, Care, and Installation Guide
Zephyr Logo
Logo Positioning Tool
P R E S R V ™
B E V E R A G E
C O O L E R
O U T D O O R