Troubleshooting - Zephyr PRB24C01AS-OD Guide D'utilisation, D'entretien Et D'installation

Troubleshooting

Possible Problem
The appliance does not
operate.
The appliance is not
cold enough.
The appliance turns on
and off frequently.
30
Possible Cause
Not plugged in.
The appliance is turned off.
The circuit breaker tripped or has a
blown fuse.
Sabbath mode may be enabled.
Temperature control setting is too
high.
External environment may require a
higher setting.
The door is opened too frequently or
for long periods of time.
The door gasket is not sealed properly.
Demonstration mode may be enabled.
The cooler does not have sufficient
ventilation.
The cooler has restricted air flow due
to too much storage.
If the outside temperature exceeds
115ºF, the unit may not operate
optimally and will affect cooling.
The room temperature is hotter than
normal.
The door gasket is not sealed properly.
The door is opened too frequently or
for long periods of time.
The cooler does not have sufficient
ventilation.
The door is not closed completely
PRB24C01AS-OD Use, Care, and Installation Guide
Solutions
Ensure the appliance is plugged in
and the power outlet has power.
Turn on the appliance.
Replace the broken fuse or reset
the breaker.
See the Operating Your Appliance
section and verify if Sabbath
mode is disabled.
Adjust the set temperature.
Keep the appliance away from
sunshine or other heat sources.
Close the door tightly and do not
open the door too frequently or
for a long period of time.
Ensure the door gasket is not
loose.
See the Operating Your
Appliance section and verify if
Demonstration mode is disabled.
Read and follow the "Installation
Clearance Requirements" in the
Installation Instructions section.
Open space in the cabinet to
allow air flow.
Place the cooler in an environment
where is the temperature is above
50ºF and below 115ºF.
Run the refrigerator at the
appropriate ambient temperature.
Ensure the door gasket is not
loose.
Close the door tightly and do not
open the door too frequently or
for a long period of time.
Read and follow the "Installation
Clearance Requirements" in the
Installation Instructions section.
Make sure the door is completely
closed.
P R E S R V ™
B E V E R A G E
C O O L E R
O U T D O O R