Trouble Shooting - Mac allister MSSP120 Notice Originale

MSSP120

Trouble shooting

Fault
Saw blades break
Motor does not function
Vibration
NOTE: The saw vibrates
slightly when the motor
is running in normal
operation.
Saw blade swings out
Holders not aligned straight
WARNING!
Switch the machine off and disconnect it
from the mains voltage before carrying out
any maintenance and adjustment works.
Possible causes
Tension incorrectly set
Load to great
Incorrect saw blade
variety
Workpiece not fed straight Avoid exerting pressure from the
Mains Gable faulty
Motor faulty
Saw incorrectely installed
Unsuitable underlay
The work bench is not
screwed down or is on the
motor
The motor is not secured
Holders not aligned
Trouble shooting
Action
Set the correct tension
Feed the workpiece more slowly
Use the correct saw blades
side
Change faulty parts
Call customer service. Do not
attempt to repair the motor yourself
as this should be carried out by
trained personnel.
Refer to the instructions given
earlier in this manual for
information on installing the saw
The heavier the work bench is,the
less the vibration. A bench made
from ply wood always vibrates more
than one made from solid wood.
Select the work bench best suited
to your working conditions
Tighten the locking lever
Securely screw the motor in place
Losen the screws with which the
holders are fastenedto the arm.
Align the holders so that they are
perpendicular to each other and
retighten the screws.
GB
39