Operation - Mac allister MSSP120 Notice Originale

MSSP120
ten the screw (F). Please note: the angle scale is a useful piece of supple­
mentary equip ment, but should not be used for precision work. Use scrap
wood for saw tests, adjust the bench if neces sary.
Horizontal saw bench and diagonal cuts, Fig. 4,5
• The saw bench can be positioned into a 45° diagonal position or be left in the
horizontal position.
• You can read off the approximate slope angle by using the angle scale lo­
cated under the work bench. For more exact adjustment, use scrap wood for
some saw tests; adjust the bench if necessary.
Fig. 4
D
Turning the grinding machine on and off Fig. 5
• The switch (6) is located on the terminal box. To turn the machine on, press
"I" (green). To turn the machine off, press "O" (red).
Changing the saw blades
A Flat saw blades, Fig. 6, 7
• Extract the saw­blade by sliding the table´s inlay (10) up, then unscrew the
ightening screw (1).
• First erase the tension by lifting the clamping lever (Fig. 7.1) upwards and if
necessary turning it anti­clockwise to further reduce the tension.
• Slightly press the upper arm down (Fig. 6).
IMPORTANT!!!
The bench should not be on the motor block, this
can cause undesireable noise.
E
90°
F
G
Fig. 5

Operation

6
31
GB