Safety Information - HeatWork CliWi Heat Cannon Manuel De L'utilisateur

COPYRIGHT: © Copyright HeatWork AS
This document may not be reproduced, transmitted, distributed, publicly displayed or stored without the prior
written consent of HeatWork, other than where this occurs solely for personal use.
Right reserved with the limitations that follow from Section 12 of the Norwegian Intellectual Property Rights Act.
PRODUCER: HeatWork AS
P.O.Box 353, N-8501 Narvik
NORWAY
Telephone: +47 76 96 58 90
www.heatwork.com
post@heatwork.com
INFORMATION: All users must be familiar with the contents of this user manual, especially information on operation and safety.
Please read the manual carefully and keep it readily available.
This manual contains information on safety, warranty, operation, technical data,, inspection and maintenance.
WARNING LABELS: Please familiarize yourself with warning labels.

1. Safety information

IMPORTANT: Please read and make sure you understand all precautions and instructions in this manual before you use your CliWi.
Keep this manual readily available for future use.
• When using electrical appliances, be sure to comply with the
following basic precautions to reduce the risk of fire, electric
shock and personal injury.
• Use necessary protective equipment, such as protective goggles
and gloves.
• The system is not equipped with EX-certified fans, and the
system must therefore never be used in an explosive
environment.
• The system is designed to be used indoors or under cover and
must not be exposed to water. See also the IP code for each
system.
• Keep out of reach of children. CliWi is intended for use by
qualified individuals only.
• Keep hair, loose-fitting clothes, fingers and other body parts
away from the air intake and outlet.
• The system fan operates on electricity. Please take precautions
to prevent electric shock when using electric equipment.
• In order to prevent dangerous situations caused by
inadvertently resetting the thermal cut-out, this device must
not be connected to an external switch, such as a time switch,
or a circuit regularly switched on and off by the device.
• Before operating the equipment, make sure you know how to
shut the CliWi down in an emergency.
• Never block the air intake or air inlet while the machine is
running.
USER MANUAL
• Never insert objects through the fan cover. Always use the
specified voltage and frequency.
• Make sure all cables are protected against short-circuiting and
overloading at all times.
• Always check electrical cables for any damage.
Replace if necessary.
• Always disconnect the CliWi from the power supply after use.
• Never pull or carry the CliWi by the power cable.
• Must not be used for ventilation of harmful, explosive,
flammable or volatile gases, smoke or substances.
• Do not use the CliWi if damaged. The CliWi must be maintained
by qualified personnel or service provider.
• During operation, make sure no unsecured objects are whirled
up. Minimum distance from wall: 0.5 metres.
• Warning! The heat exchanger may be extremely hot.
• When connecting/disconnecting, the system must be
depressurized, and the fluid temperature must not exceed 60°C.
• Hoses may be approx. 100 degrees and may pose a risk of burns
or damage. Take care to place hoses where they cannot injure
people or damage the floor or any other property.
• Use only original hoses and couplings, and make sure to follow
the instructions.
• When using extension cables, be sure to only use cables
certified and labelled for outdoor use.
14