Discharge Chute Assembly; Operating Procedures - Snow Devil WSE2013 Manuel D'instruction

ASSEMBLY INSTRUCTIONS
3. Insert the T-bolt into the hole in the inner handle section, add the connector, the
outer handle section (fig.3), and the washer.
4. Use the knob to secure the connection (fig.4). Do this on both sides to connect
the handle upper and mid section. The T-bolts should be inserted from inside
the handle of the unit so that the knobs are fastened to the outside of the
handle.
5. Follow same instructions to assemble the middle handle to the lower handle.
NOTE: Do not over-tighten the joint-fixing knobs.
6. Locate the three cable clips. Secure the power cord to the handle of the unit by
clipping them onto the handle at evenly spaced intervals.

DISCHARGE CHUTE ASSEMBLY

1. Lift the chute deflector so that it snaps and locks securely onto the discharge
chute.
2. Raise or lower the chute deflector to the desired height of the snow stream and
tighten the chute deflector knobs.
NOTE: Do not overtighten the chute deflector knobs.

OPERATING PROCEDURES

NOTE:
„ Before using this machine, make sure that the power source you will use
complies with the specifications detailed in this manual.
„ Before inserting the plug into the socket, verify that the snowthrower's auger
shaft and rubber plates are firmly secured with screws, and that the rubber
plates are facing the correct direction.
„ Check that the rotor turns freely.
9
090612