Extension Cord; Switching On And Off - Snow Devil WSE2013 Manuel D'instruction

Souffleuse electrique 20po
Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

OPERATING PROCEDURES

ExTENSION CORD

1. For safe and efficient use of you snowthrower, use only a UL- or CSA-rated
extension cord recommended for outdoor use. Refer to the extension cord
chart that follows.
Extension Cords
Max. Cord Length
15 m (50 ft.)
Wire Gauge
WARNING: Electric shock may cause SEVERE INJURY or DEATH. Heed these
warnings:
„ Do not allow any part of snowthrower to make contact with water while
powered on. If the appliance becomes wet while turned off, wipe dry before
starting.
„ Use only a UL- or CSA-rated extension cord for outdoor, all-weather use. Do
not use an extension cord over 46 metres (150 feet)
„ Do not touch the appliance or its plug with wet hands or while standing in
water. Wearing rubber boots offers some protection.
2. To prevent the extension cord from disconnecting during use, tie the female
end of the extension cord into a loose overhand knot on the top right side
of the middle frame or loop it through the cord attachment hanger (S, fig.1)
before connecting to the male plug in the switch housing socket (C, fig.1) of the
snowthrower.
3. Note that the snowthrower has a polarized male plug, with one prong in the
switch housing socket slightly longer and wider than the other. The extension
cord female end should be likewise polarized, so that the extension cord fits
snugly into the switch housing socket.
WARNING: Damaged electrical cords present risk of fire, electrical shock, and
serious bodily injury. Before operating the snowthrower, carefully examine the
electrical cord. If the cord is damaged, do not use the snowthrower. Replace or
repair the damaged cord immediately.

SWITCHING ON AND Off

1. To start your snowthrower, first press the start switch button (T, fig.5) on the
side of the switch housing.
2. Pull the safety cut-out bar (B, fig.6) toward you and hold it and the hand grip
(A, fig.6) firmly with both hands. The machine will start. The machine can only
be started by pressing the switch button first, followed by squeezing the safety
cut-out bar. Reverse operation cannot start the machine.
3. To turn the power off, release your grip on the safety cut-out bar.
10
WSE2013
30.5 m (100 ft.)
14 ga.
12 ga.
46 m (150 ft.)
10 ga.
!
!

Publicité

Table des Matières
loading

Table des Matières