Aqua Medic Titan Professional 4.000 Mode D'emploi page 11

Available spare parts: Please refer to www.aqua-medic.de.
9. Installation
After unpacking the unit, please check if it is damaged during transportation. Please contact the distributor if
there's any difference or enquiry.
1. Please ask a professional technician to install the unit and provide a special socket for the machine. Assure
the power supply is in accordance with the machine.
2. Install the product in ventilated surroundings without direct sunlight. Assure it is convenient to install pipes
and wiring.
3. Please place the machine on an even and solid surface.
4. The air cooling radiator has rear air inlet and front air outlet. Keep the rear panel of the product 20 cm away
from the wall to ensure air ventilation and product maintenance.
5. Please filter salt water before filling it into the unit. Otherwise, it may damage the titanium pipe of the
evaporator.
6. If the machine won't be used for a longer period, please cut off power supply of the unit.
7. Periodically, check and clean the condenser for assuring the performance of the unit according to the working
environment conditions.
8. Please use soft pipe to install the inlet and outlet water pipe with reasonable fixing, thus to avoid a damage
of the water inlet and outlet due to vibration of the product. Please make sure that the tubes are heat-
resistant.
9. If it is installed indoors, please make sure that the exhaust air is directed outdoors.
Tube`s diameter (In / Out) D 50
11