Storage; Disposal And Recycling - POWERTEC Garden 3911213917 Traduction Des Instructions D'origine

10. Storage

• Never store the mower (with petrol in the tank)
inside a building in which petrol fumes could come
into contact with open flames or sparks.
• Allow the motor to cool before you put the lawn
mower in an enclosed area.
• In order to avoid fire hazards, keep the engine, ex-
haust and the area around the fuel tank free from
grass, leaves and leaking grease (oil).
Preparing the mower for long-term storage
Caution: Do not empty the petrol tank in enclosed
areas, near fire or when smoking. Petrol fumes can
cause explosions and fire.
• Empty the petrol tank with a petrol suction pump.
• Start the engine and let it run until any remaining
petrol has been used up.
• Change the oil at the end of every season. To do
so, remove the used engine oil from a warm engi-
ne and refill with fresh oil.
• Remove the spark plug from the cylinder head. Fill
the cylinder with approx. 20 ml of oil from an oil
can. Slowly pull back the starter handle, which will
bathe the cylinder wall with oil. Screw the spark
plug back in.
• Clean the cooling fins of the cylinder and the
housing.
• Be sure to clean the entire machine to protect the
paint.
• Store the machine in a well-ventilated place.
Preparing the mower for transportation (Fig. 22)
• Empty the petrol tank.
• Always let the engine run until it has used up the
remainder of petrol in the tank.
• Empty the engine oil from the warm engine.
• Remove the spark plug boot from the spark plug.
• Clean the cooling fins of the cylinder and the
housing.
• Remove the start tension cable (17) from the hook.
Loosen the quick-release lever (5) and fold the
upper push bar down. Make sure the cables are
not bent during this process.
• Wedge a few layers of corrugated cardboard
between the upper and lower push bars and the
engine in order to prevent any chafing.

11. Disposal and recycling

Transport package disposal
The package protects the appliance against dam-
age during transport. Packing materials are usually
chosen depending on their environmental friendli-
ness and disposal method and can therefore be re-
cycled. Returning the package to material circulation
saves raw materials and reduces waste disposal
costs. Parts of packages (e.g. foils, styropor®) can
 www.scheppach.com  service@scheppach.com  +(49)-08223-4002-99  +(49)-08223-4002-58
be dangerous to children. Risk of suffocation!
Keep parts of packages away from children and
dispose them as soon as possible.
The unit and its accessories are made of various
types of material, such as metal and plastic.
Defective components must be disposed of as
special waste. Ask your dealer or your local
council.
Seite 31 von 56