Connections; Line Level Connection; Operation; Specifications - Pioneer S-51W Mode D'emploi

CONNECTIONS

Before making or changing any
connections, switch off the power and
disconnect both this unit and the
amplifier/receiver from the AC outlet.

LINE LEVEL CONNECTION

Rear Panel Supplied RCA plug cord
Connect the set's LINE IN terminal to the
amplifier or receiver's SUBWOOFER PREOUT
terminal using the included RCA pin cord.
NOTE:
• When connected to the PREOUT terminal
for surround center channel on the
amplifier or receiver, the bass is heard only
on the center channel, so it will be
insufficient.

OPERATION

For details regarding operating part functions,
refer to PANEL FACILITIES on page 6.
1. Turn the POWER switch (2) ON.
• If the unit's power cord is connected to a
switched AC outlet on the amplifier or
receiver and the switch is left ON, the
unit can be turned ON/OFF together with
the amplifier or receiver.
• If the unit cannot be connected to the
amplifier or receiver, turn the power to
the amplifier or receiver ON before
turning the power to the unit ON. When
turning the power OFF, turn the power to
the unit OFF before turning the power to
the amplifier or receiver OFF.
2. Operate the amplifier or receiver and
adjust the volume of the other
speakers.
3. Adjust the volume of the bass with the
VOLUME knob (3).
• When necessary, operate the PHASE
switch (5) and then adjust with the
VOLUME knob (3).
4. Turn the POWER switch (2) OFF.
• The power indicator disappears.

SPECIFICATIONS

Cabinet ............................... Bass-reflex, floor type
Speaker ....................................... 20 cm cone type
Power Amplifier Continuous Power Output
(RMS) ..................................... 150 W/6 Ω (100 Hz)
Input (sensitivity at 100 Hz)
LINE LEVEL (RCA jack)........................... 190 mV
Outline Dimension
............ 360 mm (W) x 382 mm (H) x 360 mm (D)
Weight (without package) .........................13.5 kg
Power Requirements
................................220 V to 240 V~, 50 Hz/60 Hz
Power Consumption ................................... 130 W
Power consumption in standby .........0.45 W less
Specifications and design subject to possible
modification without notice, due to
improvements.
Published by Pioneer Corporation.
Copyright © 2009 Pioneer Corporation.
All rights reserved.
7
En