Rear Panel; Connections; Line Level Connection (Å Å Å Å ) - Pioneer S-W1EX Mode D'emploi

5 5 5 5 Volume knob (VOLUME)
Sets the subwoofer volume.
• Turn the knob slowly from the MIN position.
• With this unit, the bass level can be independently
set, so do not turn up the bass on the stereo or AV
amplifier.
S-W1EX Music mode Frequency response
100
90
80
70
60
50 (Crossover 150Hz)
40
10

REAR PANEL

8 7

CONNECTIONS

Before making or changing any connections, switch
off the power and disconnect both this unit and the
amplifier/receiver from the AC outlet.
LINE LEVEL CONNECTION (
S-W1EX(Rear Panel)
This connection is for a stereo amplifier or receiver
equipped with a SUBWOOFER PRE-OUT terminal. If the
stereo amplifier or receiver is not equipped with a
SUBWOOFER PRE-OUT terminal, carry out a Speaker
Level connection. Connect to the LINE LEVEL INPUT
terminal on this unit, using the specially provided RCA
plug cord.
8
En
All manuals and user guides at all-guides.com
Bypass
Non-bypass
100
1000
Frequency (Hz)
6 0
9 -
)
Å Å Å Å
Supplied RCA plug cord
6 6 6 6 Line Level Input terminal (LINE LEVEL INPUT)
Connects to the stereo amplifier's SUBWOOFER PRE-
OUT terminal, with the specially provided RCA plug cord.
7 7 7 7 Line Level Output terminal (LINE LEVEL OUTPUT)
Used for connecting other equipment through the
amplifier. The signal output from this jack is not affected
in any way by the settings of the various controls on the
unit.
8 8 8 8 Phase switch (PHASE 0º
When set to 180º the output phase becomes the reverse
of the input signal, and when set to 0º it is in the same
phase as the input signal.
• Normally, the switch is set to 0º.
But when the sound connection between the
subwoofer and the left and right speakers sounds
unnatural, try switching to 180º
• When using two or more subwoofers together, make
sure that the phase switch of all of them are set to the
10000
same position.
9 9 9 9 Earth terminal
See CONNECTING THE SIGNAL GROUND TERMINAL on
page 10.
0 0 0 0 Speaker Level Input terminals
(SPEAKER LEVEL INPUT)
Connect to the speakers output terminals on the stereo
amplifier, using speaker cords (not supplied).
- - - - Power supply cable connector
Connect the accessory power supply cable here.
SUB WOOFER
PREOUT
NOTES:
• When connected to the PRE-OUT terminal for
surround center channel on the stereo amplifier or
receiver, the bass is heard only on the center
channel, so it will be insufficient.
/180º )