Using The Power Blender & Processor Pitcher & Dough Blade Assembly; (Max Pâte) Or Cookie Max - Ninja SS300C Série Guide De L'utilisateur

USING THE POWER BLENDER & PROCESSOR
PITCHER & DOUGH BLADE ASSEMBLY
IMPORTANT: Review all warnings on
pages 4–7 before proceeding.
IMPORTANT: As a safety feature, when
the unit is powered on, if the pitcher and
lid are not properly installed, the timer
will display "- -" and the motor will be
disabled. If this happens, repeat step 5
on the following page. When the pitcher
and lid are properly installed, and the unit
is powered on, the program button LEDs
will illuminate, indicating the appliance is
ready to use.
NOTE: Auto-iQ® programs have pauses and
changes in speed throughout the cycle.
NOTE: DO NOT add ingredients before
completing installation of the Dough
Blade Assembly.
NOTE: If the Dough Blade Assembly is
not fully seated, you will not be able to
install and lock the lid.
NOTE: The pitcher lid handle will not fold
down unless it is attached to the pitcher.
1 Plug in motor base and place on a clean,
dry, level surface such as a countertop
or table.
2 Lower the Pitcher onto the motor base.
The handle should be aligned slightly
to the right and the pitcher should be
oriented so the LOCK symbols are visible
on the motor base. Rotate the pitcher
clockwise until it clicks into place.
14 ninjakitchen.com
3 Exercising care, grasp the Dough Blade
Assembly by the top of the shaft and
place it onto the drive gear inside the
pitcher. Note that the blade assembly
will fit loosely onto the drive gear.
4 Add ingredients to the pitcher. DO NOT
add ingredients past the DOUGH MAX
(MAX PÂTE) or COOKIE MAX (MAX
BISCUIT) line on the pitcher.
5 Place the lid on the pitcher. Press down on
the handle until it clicks into place. Once
the lid is locked in place, press the Power
button to turn unit on. The available
program buttons will illuminate and the
unit will be ready for use.
6a If using an Auto-iQ® program, use the dial
to select DOUGH, then press /. The
preset feature will automatically stop at
the end of the program. To stop the unit at
any time, press /.
6b For Manual mode, press IQ/MANUAL.
Use the dial to select speeds 1 or 2, and
press /. Once the ingredients have
reached your desired consistency, press
/, and wait for the unit to come to a
complete stop.
IMPORTANT: Only use speeds 1 or 2
when using the Dough Blade Assembly.
7 Remove the pitcher from the motor base
by turning it counterclockwise and then
lifting up.
8 Remove the lid and Dough Blade Assembly
before removing contents. To remove the
lid, press the RELEASE button and lift the
handle. To remove the blade assembly,
carefully grasp it by the top of the shaft
and pull straight up. The pitcher can then
be emptied.
9 Turn the unit off by pressing the Power
button. Unplug the unit when finished.
Refer to the Care & Maintenance section
for cleaning and storage instructions.
ninjakitchen.com 15