Getting Started; Before First Use; Assembly & Use Of The Pitcher - Ninja BL610CR Guide De L'utilisateur

GETTING STARTED

The Ninja
® Professional Blender 1000 is a high powered kitchen tool that is perfect for
ice crushing, blending, pureeing and controlled processing. Create all of your favorite
recipes quickly and easily with just one touch of a button. For best results, be sure to
carefully read all the instructions contained in the manual before using this appliance.
G
I
E
H
a Lid with Locking Handle
b Locking Handle Release Button
c Pouring Spout with Cap
d Pitcher
e Stacked Blade Assembly

BEFORE FIRST USE

1 Remove all packaging material and
labels from the appliance. Separate all
parts from each other.
2 Wash the lid, pitcher, and Stacked
Blade Assembly in warm, soapy water.
When washing the blade assembly, use
a dishwashing utensil with a handle to
avoid direct hand contact with blades.
3 Handle blade assembly with care to
avoid contact with sharp edges. Rinse
and airdry thoroughly.
4 The pitcher and Stacked Blade Assembly
are dishwasher safe. It is recommended
the lid and Stacked Blade Assembly be
placed on the top rack. Ensure the Stacked
Blade Assembly is removed from the
pitcher before placing in the dishwasher.
6
ninjakitchen.com
B
D
A
C
F
f Gear Shaft
g Motor Base
(Power Cord & Cord Storage not shown)
h Control Panel
i Non Slip Bottom
5 Wipe the motor base clean with a
damp cloth.
PLEASE KEEP THESE IMPORTANT
SAFEGUARDS IN MIND WHEN USING
THE APPLIANCE:
Make sure the motor base is plugged in
for use.
NEVER add ingredients into the container
before placing the Blade Assembly in first.
DO NOT attempt to operate the appliance
without the lid on.
NEVER run the appliance empty.
Appliance accessories are not intended to
be used in the microwave, as it may result
in damage to the accessories.
ASSEMBLY & USE OF THE PITCHER
1 Review the Important Safety Instructions
on pages 1-2 before proceeding to step 2.
2 Place the motor base on a clean,
dry, level surface such as a counter
or tabletop.
3 Align and lower the pitcher onto the
motor base.
4 Rotate the pitcher clockwise until it
locks in place. You will hear a click
when the lock is engaged.
5 The pitcher can be placed on the motor
base two ways; the handle can be on the
front right corner or the front left corner.
6 Holding the Stacked Blade Assembly
by the top of the shaft, place it onto
the drive gear inside the pitcher. Ensure
the Stacked Blade Assembly is seated
properly and is standing upright.
NOTE: The Stacked Blade Assembly
will fit loosely on the drive gear.
7 Add the ingredients to the pitcher,
making sure they do not exceed the
highest measured marking line on
the side of the pitcher.
NOTE: If you need to add additional
ingredients while the appliance is
processing, open the pour spout cap
and pour the ingredients in through
the opening.
NOTE: When blending any kind of
liquids, such as mixtures of any drinks
or smoothies, do not exceed the
"Max Liquid" mark (64 ounces) on
the pitcher.
8 Plug the power cord into the electrical
outlet and press the power button ( ).
IMPORTANT: As a safety feature, the
power button ( ) will flash and the
motor will not work if the pitcher and
lid are not installed correctly. When the
pitcher and lid are installed properly,
the power button ( ) will be solid,
indicating the blender is ready for use.
ninjakitchen.com
7