Lindy Cat.6 TosLink Optical Manuel Utilisateur page 5

User Manual
Installation & Operation
Please follow the steps below for installation.
1. Connect the digital audio source to the transmitter unit using a TosLink (Optical) or coaxial cable
(not included).
2. Connect one end of a Cat.6 cable (maximum length 150m, not included) to the RJ-45 port on the
transmitter unit, and the other end of the cable to the RJ-45 port of the receiver. Please use solid
core installation cable of Cat.6 UTP or higher.
3. Connect the digital audio receiver device i.e speakers or soundbar, to the audio output port on the
receiver unit using TosLink (Optical) or coaxial cable (not included).
4. Power on both the source and receiver equipment.
5. Plug the DC power supply into the transmitter unit, power will be provided to the receiver via the
Cat.X cable using PoC.
6. For simultaneous output, connect two audio output devices to the receiver. For playback, please
ensure both sample rates are identical.
Transmitter Unit
▪
12VDC: Connect the included power supply.
▪
Cat Out: Connect a Cat.6 or higher cable of up to 150m to this port and the corresponding port on the
receiver.
▪
Coaxial In: Connect to a coaxial source device such as an audio amplifier or media player using coaxial
cable.
▪
TosLink (Optical) In: Connect to an optical source device such as a TV, media player or set top box
using TosLink (Optical) cable.
Receiver Unit
▪
Cat In: Connect a Cat.6 or higher cable of up to 150m to this port and the corresponding port on the
transmitter.
▪
Coaxial Out: Connect to a coaxial output device such as an audio amplifier or speaker set up using
coaxial cable.
▪
TosLink (Optical) Out: Connect to an optical output device such as a soundbar, amplifier or speaker
set up using TosLink (Optical) cable.
English