Handling And Operation; Display Lighting; Time; Filling The Water Tank - Beem 08769 Mode D'emploi

EN

Handling and Operation

PLEASE NOTE!
• Do not pour milk or other liquids into the water tank. Only ever use water to make
coffee!
• Never overfi ll the permanent fi lter.

Display Lighting

The display lighting goes out approx. 5 minutes after the last button has been pressed, unless the
device is in operation. To switch on the display lighting, press any button.

Time

As soon as the mains plug is plugged into a plug socket, the display lighting turns on and the time
display 12:00 starts fl ashing. The clock has a 24-hour time format.
1. Set the hours by pressing the STD (Hour) button (17).
2. Set the minutes by pressing the MIN button (15).
Hold down the respective button to run through the hours / minutes quickly.
The time is saved until a new time is set or the device has been disconnected from the
power supply.

Filling the Water Tank

1. Lift up the locking latch (11) and open the lid of the water tank (12) (Picture A).
2. Pour the quantity of water you want (min. 300 ml, max. 400 ml) into the water tank (10)
(Picture B). Note the MAX marking.
3. Close the lid using the locking latch. This must engage in place.
All of the water in the water tank always runs through, unless the brewing process is stopped
prematurely.

Inserting the Filter Holder

1. Lift up the locking latch (11) and open the lid of the water tank (12) (Picture A).
2. Insert the fi lter holder (1) into the device so that the outlet on the fi lter holder is placed in
the sealing ring in the fi lter compartment and the lid handle fi ts correctly (Picture C).
3. Close the lid using the locking latch. This must engage in place.
08769_DE-EN-FR-ES-IT_A5_V3.indb 22 08769_DE-EN-FR-ES-IT_A5_V3.indb 22
22
13.01.2020 13:57:17 13.01.2020 13:57:17