Table des Matières
Publicité
WARNING
When using the product, the safety rules must be
followed. For your own safety and that of bystanders, you
must read and fully understand these instructions before
operating the product. Please keep these instructions
safe for later use.
WARNING
The product is not intended to be used by children or
persons with reduced physical, mental or sensory
capabilities. Children should be adequately supervised
to ensure they do not play with the product.
GENERAL SAFETY WARNINGS
TRAINING
Read the instructions carefully. Be familiar with the
controls and the correct use of the product.
Never allow children, persons with reduced physical,
sensory or mental capabilities or lack of experience and
knowledge or people unfamiliar with these instructions
to use the product. Local regulations may restrict the
age of the operator.
Keep in mind, that the operator or user is responsible
for accidents or hazards occurring to other people or
their property.
Keep bystanders, children and pets 15 m away from
the area of operation. Stop the product if anyone enters
the area.
Never use the product when you are tired, ill or under
the influence of alcohol, drugs or medicine.
ELECTRICAL SAFETY
Power plugs must match the outlet. Never modify the
plug in any way. Do not use any adapter plugs with
earthed (grounded) power tools. Unmodified plugs and
matching outlets will reduce risk of electric shock.
Avoid unintentional starting. Always check that the
switch is in the Off position before plugging in the
product to the power supply. Do not carry a plugged in
product with your finger on the switch.
Avoid body contact with earthed or grounded surfaces,
such as pipes, radiators, ranges and refrigerators.
There is an increased risk of electric shock if your body
is earthed or grounded.
Do not expose this product to rain or wet conditions.
Water entering the product will increase the risk of
electric shock.
Electrical power should be supplied via a residual
current device (RCD) with a tripping current of not more
than 30 mA.
Before every use, examine the power cord for damage.
If there are signs of damage, it must be replaced by at
an authorised service centre. Always uncoil the power
cord during use; coiled cables can overheat.
If you need to use an extension cord ensure it is suitable
for outdoor use and has a current capacity rating
sufficient to supply your tool. The extension cord cable
should be marked with either "H05 RN F" or "H05 VV F".
Check the extension cord before every use for damage.
Always uncoil the extension cord during use because
coiled cords can overheat. Damaged extension cords
should not be repaired, they should be replaced with
an equivalent type.
Make sure the power cord is positioned so that it will not
be stepped on, tripped over or otherwise subjected to
damage or stress.
Never pick up or carry the product by the electric cable.
Never pull by the power cord to disconnect from the
power supply.
Keep the power cord away from heat, oil and sharp
edges.
Always direct the cable to the rear away from the
product.
Make sure voltage is correct for your product. A
nameplate on the product indicates the unit's voltage.
Never connect the product to an AC voltage that differs
from this voltage.
Make sure the switch is in Off position before
disconnecting from power supply.
PREPARATION
Some regions have regulations that restrict the use of
the product to some operations. Check with your local
authority for advice.
While operating the product always wear substantial
footwear and long trousers. Do not operate the product
when barefoot or wearing open sandals. Avoid wearing
clothing that is loose fitting or that has hanging cords or
ties; they can be caught in moving parts.
Do not wear loose clothing or jewellery that can be
drawn into the air inlet.
Secure long hair so it is above shoulder level to prevent
entanglement in moving parts.
Wear hearing protection at all times whilst operating the
product. This product is extremely noisy and permanent
hearing injury may result if precautions to limit your
exposure, reduce noise and wear hearing protection
are not strictly adhered to.
Wear full eye protection at all times whilst operating this
product. The manufacturer strongly suggests a full face
mask or fully enclosed goggles. Normal spectacles or
sun glasses are not adequate protection. Objects can
be thrown at high speed by the powerful air jet at any
time and may rebound from hard surfaces toward the
operator.
Ensure before each use that all controls and safety
devices function correctly. Do not use the tool if the "off"
switch does not stop the product.
Before each use, always visually inspect to see, that the
housing is undamaged and that guards and handles are
in place and properly secured.
Return to an authorised service centre to replace
damaged or unreadable labels.
Never operate the product with defective guards or
shields, or without safety devices, for example debris
EN
FR
DE
ES
English |
1
Publicité
Table des Matières
