Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
1) GENERAL:
- Channels
- Modulation modes
- Frequency ranges
- Antenna impedance
- Power supply
- Dimensions (in mm)
- Weight
- Accessories supplied
2) TRANSMISSION:
- Frequency allowance
- Carrier power
- Transmission interference
- Audio response
- Emitted power in the adj. channel
- Microphone sensitivity
- Drain
- Modulated signal distortion
3) RECEPTION:
- Maxi. sensitivity at 20 dB sinad
- Frequency response
- Adjacent channel selectivity
- Maximum audio power
- Squelch sensitivity
- Frequency image rejection rate
- Intermediate frequency rej. rate
- Drain
D) TROUBLE SHOOTING:
:
40
:
AM/FM
:
from 26.965 MHz to 27.405 MHz
:
50 ohms
:
13.2 V
:
160 (L) x 240 (H) x 55 (D)
:
1.6 kg
:
Microphone with support,
mounting cradle, screws.
:
+/- 300 Hz
:
1 W AM / 4 W FM
:
inferior to 4 nW (- 54 dBm)
:
300 Hz à 3 KHz in AM/FM
:
inferior to 20 μW
:
1,0 mV
:
1,7 A (with modulation)
:
1,8 %
:
0. μV - 113 dBm (AM/FM)
:
300 Hz à 3 kHz in AM/FM
:
60 dB
:
5 W
:
minimum 0.2 μV - 120 dBm
maximum 1 mV - 47 dBm
:
60 dB
:
70 dB
:
500 mA nominal
800 mA maximum
1) YOUR CB RADIO WILL NOT TRANSMIT OR YOUR TRANSMISSION
IS OF POOR QUALITY:
- Check that the antenna is correctly connected and that the SWR is properly adjusted.
- Check that the microphone is properly plugged in.
2) YOUR CB RADIO WILL NOT RECEIVE OR RECEPTION IS POOR:
- Check that the squelch level is properly adjusted.
- Check that the volume is set to a comfortable listening level.
- Check that the microphone is properly plugged in.
- Check that the antenna is correctly connected and that the SWR is properly adjusted.
- Check that you are using the same modulation mode as your correspondent.
3) YOUR CB WILL NOT LIGHT UP:
- Check the power supply.
- Check the connection wiring.
- Check the fuse.
E) HOW TO TRANSMIT OR RECEIVE A MESSAGE:
Now that you have read the manual, make sure that your CB Radio is ready for use (i.e.
check that your antenna is connected).
Choose your channel (19, 27).
Choose your mode (AM/FM) which must be the same as that of your correspondent.
Press the «push-to-talk» switch and announce your message «Attention stations,
transmission testing» which will allow you to check the clearness and the power of your
signal. Release the switch and wait for a reply. You should receive a reply like, «Strong
and clear».
If you use a calling channel (19, 27) and you have established communication with
someone, it is common practice to choose another available channel so as not to block
the calling channel.
F) GLOSSARY:
Below you will find some of the most frequently used CB radio expressions. Remember
this is meant for fun and that you are by no means obliged to use them. In an
29
Publicité
Table des Matières
