shark NV370 Manuel Du Propriétaire page 16

™
Dust-Away Hard Floor Attachment - Use and Care
IMPORTANT: Use only in
Portable Lift-Away
®
Fig. 17
ATTACH PAD
Slip two of the tabs between the suction nozzle and
™
the Dust-Away base and attach them to the front
fasteners on the base. Then pull the other two tabs
tightly around to the back fasteners on the base. For
best results, ensure that the pad is flat against the
bottom surface and secured tightly. (Fig. 17)
CLEAN THE FLOOR
Press the extension wand release button and pull the
1
extension wand up. (Refer to page 14, Fig. 14-b)
Attach Dust-Away hard floor attachment onto the
™
2
end of the extension wand. (Fig. 18)
Press the On/Off switch to the "I" position to
3
turn the suction motor on and begin cleaning
all hard surfaces.
IMPORTANT: Do not use to clean damp floors or
wet/sticky messes.
CARE FOR PADS
Wash the pads separately with warm water
1
either in the washing machine or by hand
using liquid detergent.
16 TOLL FREE: 1-800-798-7398
mode.
Fig. 18
Do not use bleach or fabric softeners as they may
2
damage or leave a coating that will reduce the
cleaning performance of the pads.
Tumble dry low or line dry to extend the life of the
3
micro-fiber fabric.
REPLACE PADS
For best floor cleaning results, we recommend
1
replacing your micro-fiber pads every 3-4 months
following normal use.
You can find and purchase replacement micro-fiber
2
dusting pads and accessories
at www.sharkclean.com
TO REPLACE THE MOTORIZED FLOOR BRUSH
FOR UPRIGHT CLEANING
Press the red release at the bottom of
1
the extension wand and remove the
hard floor attachment.
Replace the canister back onto the motorized floor
2
brush and re-insert the handle with extension wand
back into the top of the vacuum body until you hear
these click into place.
When attaching the motorized floor brush, ensure
that the locking mechanism is fully locked in place to
ensure electrical connection has been made.