Microfiber Pads - Steamfast SF-294 Mode D'emploi

Assembling Your
3-in-1 Steam Mop
STEAM MOP SETUP
EXTENSION POLE
1. Insert threaded connector on bottom of Extension Pole into pole base on main unit
(FIGURE 1-A).
2. Rotate Extension Pole in a clockwise direction as shown to screw it into pole base
(FIGURE 1-B). Make sure Pole is tightly secured to main unit.
3. To adjust length of Extension Pole:
A) Rotate upper (thicker) section of Extension Pole in "UNLOCK" direction indicated on label to
unlock it (FIGURE 1-C).
B) Adjust upper section to desired length (FIGURE 1-D).
C) Rotate upper section of Extension Pole in "LOCK" direction indicated on label to lock it back
in place (FIGURE 1-E).
NOTE: Increasing length of Extension Pole may provide additional leverage for easier,
more effective steam mopping.
POLE
BASE
A
B
C D
UPPER SECTION
6 | ENGLISH
THREADED
CONNECTOR
E
FIGURE 1
MOP HEAD
CAUTION: Always allow unit to cool before connecting/disconnecting any accessories.
1. Align Mop Head with main unit as shown (FIGURE 2), so that neck is in line with Steam Nozzle.
2. Slide Mop Head neck into Steam Nozzle, pressing firmly until release button snaps through hole.
3. To remove Mop Head, press firmly on release button while simultaneously pulling Mop Head
away from Steam Nozzle.
MOP
HEAD STEAM
NECK NOZZLE
RELEASE
BUTTON

MICROFIBER PADS

1. Lay one Microfiber Pad on flat surface, with two fastener strips facing upward.
2. Align Mop Head above Microfiber Pad. Make sure Mop Head is oriented with Pad as shown,
and centered as best as possible (FIGURE 3-A).
3. Press Mop Head firmly down onto Microfiber Pad. Fastener strips will adhere to pad grips on
underside of Mop Head. Pad should now be attached and ready for use (FIGURE 3-B).
CAUTION: Use care when handling a recently used Microfiber Pad, as it may still be hot.
NOTE: Microfiber Pads are machine washable. To avoid picking up lint, washing
separately from other fabrics is recommended. Only use liquid detergent. Avoid using
any fabric softeners or bleach. Air drying is recommended; machine drying on a low
setting is acceptable as well.
HOLE
FIGURE 2
A B
FIGURE 3
ENGLISH | 7