Water Connection; Electrical Connection - Victoria Arduino EAGLE ONE PRIMA Manuel D'instructions

1
2
IN
3 3
4.2
WATER
CONNECTI ON
Avoid throttling in the connect-
ing tubes. Assess that the drain
pipe is able to eliminate waste.
It is forbidden to use connect-
ing pipes already used in the
past. Filter maintenance is the
responsibility of the purchaser.
Mesh filter
1
Softener
2
3 Drain 50 mm
Failing to maintain water into
the correct levels will void the
warranty.
The machine must be in-
stalled according to the ap-
plicable federal, state, and
local standards (codes) in
force with regard to plumb-
ing systems including back-
flow prevention devices. For
this reason, the plumbing
connections must be carried
out by a qualified technician.
OUT
WATER SPECIFICATIONS
• Total hardness 50-60 ppm
(parts per million).
• Water line pressure be-
tween 2 - 5 bar and water
to be cold.
• Min flow rate: 200 l/hr.
• Filtration level below 1.0 mi-
cron.
• tds (total dissolved solids)
level between 50 – 250
ppm.
• Alkalinity level between 10
- 150 ppm.
• Chlorine level less than
0.50 mg/l.
• ph level between 6.0 - 8.0.
E AG L E O N E P R I M A | L I B R E T TO I ST R UZ I O N I - U S E R H A N D B O O K - M A N U E L D 'I N ST R U CTI O N S | 4 6
4.3
ELECTRI CAL
CONNECTI ON
Prior to connecting
machine to the electrical
mains, assess that
voltage shown on
machine's data
corresponds with that of the
mains.
ELECTRICAL
SPECIFICATIONS
230V - monophase voltage
the
the
the
plate