Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
• To prevent danger-
ous overheating, it is
advisable to fully ex-
tend the power sup-
ply cord. Never block
the
intake
and/or
heat dissipation grills,
in particular those for
the cup warmer.
• The user must nev-
er replace the unit's
power supply cord. If
this cord is damaged,
turn off the unit and
have it replaced by a
professionally quali-
fied technician.
• Should it be neces-
sary to replace the
power cord, this re-
placement operation
must only be per-
formed by an author-
ized service centre or
by the manufacturer.
• The device needs to
be supplied with wa-
ter that is suitable for
human
consump-
tion and compliant
with the regulations
in force in the place
of
installation.
installation engineer
needs
confirmation
from the owner/man-
ager of the system
that the water com-
plies with the require-
ments and standards
stated above.
• For machines con-
nected to the mains
water
supply,
minimum
must be 0.2 MPa (2
bar) and the max-
imum
pressure
correct machine op-
eration must not ex-
ceed 0.65 MPa (6,5
bar).
• If present, an an-
ti-flooding
must be installed up-
stream of the soften-
er in accordance with
IEC EN 61770.
• The operating tem-
perature
must
within the range of
[+5, +25]°C. In case
of prolonged storage
at a temperature be-
low 2 °C, empty the
machine
system to prevent it
from freezing. In case
of freezing, do not
switch the machine
The
on before having re-
conditioned it for at
least 1 hour at a suit-
able room tempera-
ture.
• At the end of instal-
E AG L E O N E P R I M A | L I B R E T TO I ST R UZ I O N I - U S E R H A N D B O O K - M A N U E L D 'I N ST R U CTI O N S | 37
lation, the device is
switched on and tak-
en to rated operating
conditions, leaving it
in a state in which it is
the
"ready for operation".
pressure
• After
"ready for operation"
condition, the follow-
for
ing dispensing oper-
ations are carried out:
• 100% of the coffee
circuit through the
coffee
(for more than one
system
dispenser, this is di-
vided equally);
• 100% of the hot wa-
ter circuit through
the water dispens-
er (for several dis-
be
pensers it is divided
equally).
• Open
outlet for 1 minute.
• At the end of installa-
tion, it is good prac-
hydraulic
tice to draw up a re-
port of the operations.
• It is forbidden to leave
the machine switched
on without the pres-
ence and surveillance
of a qualified opera-
tor. Simonelli Group
is not responsible for
damages caused by
failure to comply with
this prohibition.
• Be extremely care-
ful when using the
steam
er place your hands
under the wand and
reaching
the
never touch it right
after use.
• Before cleaning the
unit, follow the in-
structions
this manual at chap-
ter 9 carefully.
dispenser
• Once
washing machine, do
not interrupt, the de-
tergent residue may
remain inside the de-
livery unit.
• In
down or poor func-
tion, turn off the unit.
Never
the
steam
the unit. Contact only
professionally
ified personnel. Only
the manufacturer or
an authorized service
center can make re-
pairs and only using
original spare parts.
Non compliance with
the above can com-
promise
safety.
• In case of fire, dis-
connect power to the
machine by turning
wand.
Nev-
given
in
started
the
case
of
break-
tamper
with
qual-
machine
Publicité
Table des Matières
