Clean Lock Function; Safety Precautions And Recommendations - Brandt BPI163DUB Manuel D'instruction

USE USE

CLEAN LOCK function:

The Clean Lock function allows the table to be
temporarily locked during cleaning.
To activate the Clean Lock function, press the
button briefly, a beep will sound and the
symbol will flash. After about 1 minute, the lock is
automatically deactivated. A double beep is heard
and the symbol disappears. You can deac-
tivate the Clean Lock function at any time by
pressing and holding the
SAFETY PRECAUTIONS AND RECOMMENDA-
TIONS
Residual heat:
After intensive use, the cooking zone that you
have just used can remain hot for several minutes.
The symbol H is displayed during this period .
Avoid touching the areas concerned during this
time.
Anti-overheat protection:
Each cooking zone has a safety sensor that
constantly monitors the temperature of the
bottom of the cookware. In the event that empty
cookware is left on a cooking zone that is switched
on, the hob automatically lowers the power output
and thus limits any risk of damage.
Protection against overflows
A special display (symbol
followed with the hob swit-
ching off, may be triggered in the following cases:
- Overflow that spills onto the buttons
- Damp towel placed over the buttons.
- Metallic object placed on the buttons
Remove the object or clean and dry the touch
controls, then restart cooking.
button.
), a sound signal,
Auto-Stop :
Your hob has an auto-stop device, which automa-
tically stops any cooking zone which remains swit-
ched on for an excessive length of time (between
1 and 10 hours depending on the power used).
If this safety system is triggered, the cut-off to
the cooking zone is shown with the "AS" display
on the control panel and a beep sounds for about
2 minutes. Simply press any of the buttons to stop
this.
Tips
Sounds which are similar to those of a clock
mechanism may be given off.
These noises occur when the hob is working. They
disappear or reduce depending on the heating
configuration. There may also be whistling sounds
depending on the model and quality of your
cookware. The noises described are normal. They
are related to induction technology and do not
indicate a problem.
Tips
We do not recommend a protective device.
EN
15