Remote Control - Madison MAD-HIGHPOWER400CD Manuel D'utilisation

ENGLISH
RECOMMENDATIONS FOR BATTERIES
This symbol indicates that used batteries should not be disposed of with household waste but deposed correctly in accor-
dance with your local regulations..
Batteries shall not be exposed to excessive heat such as sunshine, fire or the like.
When the internal batteries are not to be used, remove them to avoid damage caused by battery leakage or corrosion.
ATTENTION
Danger of explosion if battery is incorrectly placed.Only replace by the same or equivalent type.
WARNING
Do not swallow the battery. Danger of chemical burns.Keep new and old batteries out of the reach of children.
If the battery compartment doesn't close properly, stop using the product and keep it out of the reach of children.
If you are in doubt whether the batteries have been swallowed or introduced into any other part of the body, contact immediately a
doctor.

REMOTE CONTROL

ON: Switches the unit on.
OFF: Switches the unit off
MUTE: Mutes the audio on the amplifier. Press again to cancel. (Press VOL+ or VOL- will
cancel Mute as well).
INPUT: Select the input source among USB/CD, BLUETOOTH, LINE (AUX)
STOP: Stops the music playback from USB/CD
TONE: Press to select TREBLE, BASS and press VOL+ / VOL- to increase/decrease bass or
treble
RPT: When CD input is selected, press once to repeat current song. "RPT ONE" is dis-
played. Press again to repeat all sonts on the CD. "RPT ALL" is displayed.
When USB is selected, 3 repeat modes are available: RPT ONE, RPT ALL and RPT FOLD. It
means repetition of the current song, repetition of all songs on the USB stick and repeti-
tion of all songs in one folder.
EQ: Select one of the 3 EQ pre-sets and DSP OFF: Classic, Pop, Rock.
Number buttons: In DISC/USB mode, select the number of the song you want to play.
VOL+: Press to increase the volume
VOL-: Press to decrease the volume
: Press to select previous song
: Press to select next song
: Press to play/pause music from USB/CD/BLUETOOTH input source
CONNECTION OF BLUETOOTH
Press input selector key on the front panel or on the remote control and select the Bluetooth input. Turn the
Bluetooth function on your equipment on (such as mobile phone) and search for a Bluetooth device. The Bluetooth
name is "MAD-HIGHPOWER400CD", pair your mobile to "MAD-HIGHPOWER400CD", and connect it. Now you can
play your music.
PLAY CD DISK
This product supports CD, MP3 & WAV music formats. Please insert the CD with the label side upside and accept
standard CD disks only
TROUBLE-SHOOTING
If the product is not operating properly, make a check of the items in the table below. If the problem persists, a
malfunction may be assumed. Disconnect the power immediately and contact the store where the unit was pur-
chased.
4
© Copyright LOTRONIC 2019