Husqvarna WS 482 HF Manuel D'utilisation page 14

4. Hold the 16 mm wrench in position and tighten the 2
stop screws with a 3 mm hex key (B).
5. Push down the lock device and pull the saw carriage
in the 2 directions by hand. Make sure that the saw
carriage moves easily and that all 4 guide wheel
rotate.
6. Tighten the 2 M10 screws with a 8 mm hex key (A).
To adjust the saw carriage
1. Loosen the 2 stop screws with a 3 mm hex key (A).
C
A
B
2. Turn the 2 sleeves with a 8 mm hex key until the
shaft is tight and parallel to the saw unit (B).
3. Tighten the 2 stop screws with a 3 mm hex key (A).
4. Close the lock handle and make sure that the spring-
loaded lock stays in locked position (C).
5. Use the pin to lock the handle.
To cut concrete blocks
WARNING:
heavy and can cause serious injury. Make
sure that the concrete block to be cut is
attached safely before operation.
1. Examine the dimensions of the concrete block to be
cut and make sure that it is safe to lift and remove.
2. Divide a large concrete block into smaller parts if it is
necessary. It is not necessary to move the rail or the
wall supports. You can cut on the 2 sides of the rail.
14
Concrete blocks are very
3. Put the holes for the wall supports approximately
165 mm/6.5 in (A) from the sawing groove. Use
expander bolts.
A
A
A
A
A
A
WARNING:
wall supports to the concrete block
that is to be cut.
Note:
In the corners, the same holes can be
used for vertical and horizontal cuts.
4. Cut the concrete block in the sequence that follows.
The illustration shows the work procedure when you
divide a concrete block into 3 sections.
E
a) Do the horizontal cuts first. Start from the bottom
(A), (B), (C), (D).
b) Do the 2 vertical cuts (E).
5. Install wedge anchors after each cut. Install 2 wedge
anchors on the sawing side and 1 wedge anchor on
the other side of the concrete block.
6. When you make the last cut, attach the rail on a
stable wall. Use the included wedges.
Blade drive modes
There are 2 blade drive modes for the product. The
blade drive modes are selected in the main menu.
A
A
A
A
A
A
Do not attach the
D
C
E
B
A
1675 - 001 - 11.06.2021