Lindy 38208 Manuel Utilisateur page 6

User Manual
IR Pin Out
Installation & Operation
The following steps are for an installation using HDMI equipment, if you are using DVI equipment, please
substitute HDMI cables for DVI to HDMI cables where required. The suggested maximum input and output
HDMI cable length is 3m (9.84ft) in, and 3m (9.84ft) out.
▪
Connect the HDMI source to the "HDMI IN" port on the transmitter using an HDMI cable.
▪
Connect one end of a Cat.5e/6 cable or higher to the "CAT OUT" port on the transmitter, and the other
end to the "CAT IN" port on the receiver.
▪
To utilize the loop out feature, connect a local display or projector to the "HDMI OUT" port on the
transmitter using an HDMI cable.
▪
Connect the remote display to the "HDMI OUT" port on the receiver using an HDMI cable.
▪
Connect the included IR emitter cable to the "IR OUT" port on the transmitter, and the IR receiver cable
to the "IR IN" port on the receiver.
▪
Ensure the emitter's eye is in line with the IR receiver on the source device.
▪
Ensure that the IR receiver is in a clear line of sight of the remote control.
▪
To copy the EDID of the local display, please move the dipswitch to Tx. To copy the EDID of the remote
display, please move the dipswitch to Rx.
▪
Connect the locking DC power supply to the 12VDC port on the transmitter. The transmitter and
receiver will immediately turn on, then switch on the display(s) and finally the source device.
▪
The installation is now complete.
English