Lindy 38208 Manuel Utilisateur page 5

User Manual
Product Diagram
Transmitter
▪
HDMI In: Connect an HDMI source device.
▪
EDID Dipswitch: This switch can be used to select an EDID to copy. If switched to Tx, the extender will
copy the local HDMI loop-out display's EDID. If switched to Rx, the extender will copy the remote
display's EDID.
▪
HDMI Out: Connect a local HDMI display.
▪
IR Out: Connect the included IR emitter cable for controlling the source device.
▪
Power LED: This LED will illuminate once power has been connected.
▪
Cat Out: Connect a Cat.5e or Cat.6 cable.
▪
12VDC: Connect the included power supply.
Receiver
▪
HDMI Out: Connect an HDMI display.
▪
IR In: Connect the included IR receiver cable for control of the source device from the display side.
▪
Power LED: This LED will illuminate once power has been connected.
▪
Cat In: Connect the Cat.5e or Cat.6 cable from the transmitter.
English