BOMANN KB 389 Mode D'emploi page 20

Cleaning and Maintenance Cleaning
Cleaning Cleaning
WARNING: WARNING: WARNING: WARNING:
• Always disconnect the appliance from the power
supply before cleaning and user maintenance.
• Do not use steam cleaners for cleaning the appli-
ance; moisture could enter electrical components.
Risk of electric shock! Risk of electric shock! Hot steam could damage Risk of electric shock! Risk of electric shock!
the plastic parts.
• The unit must be dry before restarting operation.
CAUTION: CAUTION:
CAUTION: CAUTION:
• Do not use a wire brush or other sharp, abrasive
items.
• Do not use any acidic or abrasive detergents.
• Do not damage the refrigerant circuit.
Cleaning the appliance including interior Cleaning the appliance including interior
Cleaning the appliance including interior Cleaning the appliance including interior
• Clean the appliance interior, the exterior surfaces,
the accessories and the door seal regularly with
warm water and mild detergent.
• Remove for that the appliance content and stor-
age at a cool location.
• After everything was thoroughly dried, you can
restart the operation.
Defrosting De frosting
De De frosting frosting
CAUTION: CAUTION: CAUTION: CAUTION:
Never use metal objects (e.g. knifes) to remove ice
from the evaporator. Otherwise it can be damaged.
A defect evaporator can cause serious damage.
To achieve better cooling and to save energy, defrost
the appliance regularly as follows:
• To start the defrosting process, turn the tempera-
ture control to the off state and disconnect the
appliance from the power supply.
• Remove the food items and keep covered at a
cool location.
• When the ice has melted, wipe the condensate
away and dry the appliance interior.
and Maintenance
and Maintenance and Maintenance
• Then you may restart the appliance by connecting
the plug and turning the temperature control.
Troubleshooting Troubleshooting
Troubleshooting Troubleshooting
Before you contact an authorized specialist Before you contact an authorized specialist Before you contact an authorized specialist Before you contact an authorized specialist
Problem Problem Problem Problem Cause / Action Cause / Action Cause / Action Cause / Action
Unit is not - Check the power supply.
working - Check the temperature setting.
properly or - Check the ambient temperature.
at all - Check the appliance content.
- Unblock the ventilation openings, install
the appliance freely.
Stored food - Check the temperature setting.
is too warm - Open the door only as necessary.
- Check the location.
Loud noise - Check the appliance position.
during oper- - See the section "Operating noise".
ation
Water on the Check the temperature setting.
appliance
bottom
Water on the On days of high humidity, condensation
outer surface might occur on the outer appliance sur-
face. No malfunction!
NOTE: NOTE:
NOTE: NOTE:
If a problem persists after following the steps above,
contact your trader or an authorized technician.
Technical Data Technical Data
Technical Data Technical Data
Electrical connec c c c tion............................................ Electrical conne Electrical conne Electrical conne tion............................................ tion............................................ tion............................................
Mains voltage: ........................................220-240 V~
Mains frequency: ...........................................50 Hz
Power consumption: ........................................70 W
Dimension H x W x D / Weight............................... Dimension H x W x D / Weight............................... Dimension H x W x D / Weight............................... Dimension H x W x D / Weight...............................
Appliance size: .........................51.0 x 43.9 x 47.0 cm
Net weight: ......................................approx. 14.0 kg
The right to make technical and design modifications
during continuous product development remains
reserved.
20