• Dismount the lower door hinge (5) by loosening
the screws (6).
• Displace and attach the door hinge (5) at the op-
posite appliance side. Turn in the feet (7+8) ac-
cordingly.
• Replace the appliance upright. Put the appliance
door on the hinge pin and fix it in its intended po-
sition.
• Displace and attach the upper door hinge (4) at
the opposite appliance side.
• Insert in the blind cap (1) at the opposite hole and
put on the hinge cover (2) again, which you have
removed at the beginning.
• Check if the door is aligned vertically and horizon-
tally optimally so that the smooth opening and
closing of the door is guaranteed.
Startup / Operation
Startup / Operation
Startup / Operation
Startup / Operation
Prior to first use
Prior to first use
Prior to first use
Prior to first use
CAUTION
CAUTION
CAUTION
CAUTION: : : :
After transport, the appliance should be left standing
upright for about 4 hours before connecting to the
power supply. Nonobservance could lead to malfunc-
tion of the cooling system and causes an appliance
breakdown.
Clean the appliance interior including all accessory
parts. Consider the instructions which we provide in
the chapter "Cleaning and Maintenance".
Starting the appliance
Starting the appliance
Starting the appliance
Starting the appliance
• Connect the appliance to the power supply.
• Operate the temperature control. See also the
following section "Settings".
Settings
Settings
Settings
Settings
Setting [0] means that the appliance is in the off
state. Turn the temperature control clockwise, start-
ing from this setting; the appliance will turn on auto-
matically.
The power levels [1–7] regulate the different values
of the internal temperature.
Setting 0
Setting 0
Setting 1
Setting 1
Setting 0
Setting 0
Setting 1
Setting 1
Off state
Lowest setting
(warmest inside
temperature)
Note that the temperature will change depending on
the ambient temperature, frequency of door opening
and the amount of food in the appliance.
During initial operation, turn the temperature control
to the highest setting first, until the appliance has
reached the desired operating temperature. After-
wards it is recommended to turn the control back to a
medium setting; correcting the temperature at a later
point would then be easier.
Storing food
Storing food
Storing food
Storing food
NOTE: Recommendation!
NOTE:
Recommendation!
NOTE:
NOTE:
Recommendation!
Recommendation!
To guarantee that the temperature is low enough,
you should pre-cool the appliance a few times before
initial loading foods.
CAUTION:
CAUTION:
CAUTION:
CAUTION:
Always pay attention to the storage instructions on
the sales packaging.
Always store food covered or packed to prevent dry-
ing-out and transfer of odor or taste onto other food
items. You may pack the food with e.g.
• Polyethylene plastic bags or foil
• Plastic bowl with lid
• Special plastic covers with elastic strip
• Aluminum foil
18
Setting 7
Setting 7
Setting 7
Setting 7
Highest setting
(coldest inside
temperature)