BOMANN KB 389 Mode D'emploi page 17

ficient cooling operation at low power consump-
tion. Enough clearance is necessary.
Gap to the back and to the side walls each ap-
-
prox. 5 cm;
Place the appliance so that the appliance door
-
can open without being impeded.
• Only install at a location with an ambient tempera-
ture suitable for the climate class of the appliance.
For information on the climate class, please refer
to chapter "Technical Data" or to the rating label
located in the interior or on the rear side of the
appliance.
• Place the appliance on a steady and safe surface.
If the appliance is not horizontally leveled, adjust
the feet accordingly.
• Avoid the installation: Avoid the installation: Avoid the installation: Avoid the installation:
near heaters, next to a stove, direct sunlight or
-
any other heat sources;
at locations with high humidity (e.g. outdoors,
-
bathroom), as metal parts would be suscepti-
ble to corrosion under such circumstances;
near volatile or flammable materials (e.g. gas,
-
fuel, alcohol, paint, etc.), in rooms which may
have poor air circulation (e.g. garages).
Do not expose the appliance any weather.
-
Electrical connection Electrical connection
Electrical connection Electrical connection
WARNING: WARNING: WARNING: WARNING:
• The installation to the mains supply must conform
to the local standards and regulations.
• Improper connection may cause to an electric
shock! shock
shock shock
• Do not modify the appliance plug. If the plug does
not fit properly to the outlet, let install a proper
outlet by an authorized specialist.
• The accessibility of the power plug must be en-
sured to disconnect the appliance from the power
supply in case of emergency.
CAUTION CAUTION: : : :
CAUTION CAUTION
In case of disconnection or power failure:
Wait for approx. 5 minutes before restarting.
-
Check the operation settings.
-
• Ensure that your mains power corresponds with
the specifications of the appliance. The specifica-
tions are printed on the rating label.
• Connect the mains cable to a properly installed
and earthed wall outlet.
• If the plug after installation is not accessible, a
corresponding disconnect device must be availa-
ble to meet the relevant safety regulations.
Reverse the Reverse the door o Reverse the Reverse the
If required, the door opening can be moved from the
right (supplied condition) to the left side.
WARNING: WARNING: WARNING: WARNING:
When replacing the door stop, the appliance must be
disconnected from the power supply first.
NOTE: : : : NOTE
NOTE NOTE
• Ask another person to assist.
You possibly need:
•
driver as well as a thin-blade screwdriver.
• Remove the blind cap (1) and the hinge cover (2).
electric
electric electric
• Dismount the upper door hinge (4) by loosening
the screws (3). Open the appliance door a little
and lift it out of the lower door hinge.
• Displace the blind plug (9) of the appliance door
accordingly. Place the appliance door safely
aside.
• Tilt the appliance slightly backwards and block it
in this position. Unscrew the feet (7+8).
17
door opening door o door o pening pening pening
screw wrench, Phillips screw-