Assembly And Adjustments - DeWalt D28499 Guide D'utilisation

Complete electronic control™
DWE4597, DWE4597n, DWE4599n
The internal electronic speed control offers consistent wheel
speed while using the tool.
Electronic Soft Start
DWE4597, DWE4597n, DWE4599n
This feature limits the initial start up momentum, allowing
the speed to build up gradually over a 1 second period.

ASSEMBLY AND ADJUSTMENTS


WARNING: To reduce the risk of serious personal
injury, turn unit off and disconnect it from
power source before making any adjustments or
removing/installing attachments or accessories.
An accidental start-up can cause injury.
Attaching Side Handle (Fig. B)
The side handle can be fitted to either side or the top of
8
the gear case in the threaded holes. The side positions are
designed for optimized balance in surface finishing and
grinding applications. The side handle must be used at all
times to maintain proper control of the tool. Before using
the tool, check that the handle is tightened se cure ly.
Fig. B
nOTE: The D28499 offers 5 handle locations for
additional versatility.
AntI-Vibration Side Handle
DWE4597, DWE4597n, DWE4599n
The anti-vibration side handle reduces vibration and user
fatigue in extended use applications.
Gear Case Grip (Fig. C)
DWE4559Cn, DWE4559Cng
The DWE4559CN and DWE4559CNG include a soft grip
cover for the gear case that can be used as a gripping
surface only for pipeline grinding and wire brushing where
the edge of the wheel is used for grinding and cleaning and
precise control is needed to ensure accuracy. As with any
gripping surface, maintain firm grip during use. The side
handle should be used as the secondary grip surface for all
other applications.
Fig. C
The gear case grip may be purchased at additional cost.
Please call 1–800–4-D WALT (1–800–433–9258) or visit our
e
website: www.D WALT.com.
e
Rotating the Gear Case (Fig. D)
For applications in which a tool will be dedicated for uses
in edge grinding and finishing work, the gear case may be
rotated 90° left or right of its original position.
Fig. D
1. Remove the four corner screws attaching the gear case
to motor housing.
2. Without separating the gear case from motor housing,
rotate the gear case head to desired position.
nOTE: If the gear case and motor housing become
separated by more than 1/8" (3.17 mm), the tool must be
serviced and re-assembled by a D
Failure to have the tool serviced may cause brush, motor
and bearing failure.
3. Reinstall screws to attach the gear case to the
motor housing. Tighten screws to 20 in.-lbs. torque.
Overtightening could cause screws to strip.
Rotating the Rear Handle (Fig. E)
D28499 Only
1. Unlock the rear handle by pulling out the handle re lease
lever .
12
Fig. E
12
English
WALT service center.
e
7