Sony CMT-SBT40D Mode D'emploi page 32

There is no sound.

The USB device is not connected correctly.
Turn off the system, and then reconnect the
USB device.
There is noise, skipping, or distorted sound.

An unsupported USB device is connected.
Connect a supported USB device.

Turn off the system, then reconnect the USB
device and turn on the system.

The music data itself contains noise, or the
sound is distorted. Noise may have been
entered when creating music data due to the
conditions of the computer. In this case,
delete the file and send the music data again.

The bit rate used when encoding the files was
low. Send files encoded with higher bit rates
to the USB device.
"SEARCH" is displayed for an extended time,
or it takes a long time before playback
starts.

The reading process may take a long time in
the following cases.
 There are many folders or files on the USB
device.
 The file structure is extremely complex.
 Not enough free space in the memory.
 The internal memory is fragmented.
The file or folder name (album name) is not
displayed correctly.

Send the music data to the USB device again,
as the data stored in the USB device may have
been corrupted.

The character code that can be displayed by
this system are as follows:
 Upper cases (A to Z).
 Numbers (0 to 9).
 Symbols (< > +, [ ] \ _).
Other characters appear as "_."
The USB device is not recognized.

Turn off the system and reconnect the USB
device, then turn on the system.

An incompatible USB device may be
connected.

The USB device does not work properly. Refer
to the operating manual supplied with the
USB device for how to deal with this problem.
32
GB
Play does not start.

Turn off the system and reconnect the USB
device, then turn on the system.

An incompatible USB device may be
connected.
Play does not start from the first track.

Make sure the current play mode is correct. If
the play mode is "SHUFFLE", change the
setting (page 13).
The USB device cannot be charged.

Make sure the USB device is connected
securely to the  (USB) port .

The USB device may not be supported by this
system.

Disconnect the USB device and then reconnect
it. For details on the charging status of the
USB device, see the operating manual of the
USB device.
Tuner
Severe hum or noise occurs ("STEREO"
flashes in the display window ), or
broadcasts cannot be received.

Connect the antenna properly.

Find a location and an orientation that provide
good reception, and then set up the antenna
again.

Keep the antennas away from the unit or
other AV components to avoid picking up
noise.

Turn off nearby electrical equipment.
Several radio stations can be heard at the
same time.

Find a location and an orientation that provide
good reception, and then set up the antenna
again.

Bundle the antenna cables using
commercially available cord clips and adjust
the cable lengths.
To reset the system to factory
settings
If the system still does not operate properly,
reset the system to factory settings.
1
Turn on the system.