Connecting With Bluetooth Devices; Using The Timer Function - Metabo HPT UR 18DSAL Mode D'emploi

Close the front cover after selecting tracks and
adjusting volume.
NOTE
You may be unable to raise the volume level if the
volume level of the external device is too low.
NOTE
○ When connecting a smartphone, please be aware
that the ringtones of incoming calls for some
models are not output to speaker.
○ External devices may be damaged if used in
locations exposed to the sun or hot temperatures.
○ See page 19 when recharging with USB in
"AUX" mode.
CONNECTING WITH BLUETOOTH
DEVICES
If smartphones, portable music players and other
devices are Bluetooth compatible, audio can be
output from this product via Bluetooth communication.
1. Pairing (Registering devices)
Pairing is required for Bluetooth communication.
Set your Bluetooth device to pairing mode.
(For instructions on pairing, see the manual for the
Bluetooth device to be used.)
2. Set the radio for pairing mode
Press the Source select button and display
"Bluetooth".
Bluetooth
Long press the Play / Stop button (located
between the Search buttons) until the displayed
"Bluetooth" is fl ashing.
(Long Press)
Select "UR18DSAL" on your Bluetooth device's
list of connected devices to complete the pairing.
3. Input pass key
Some Bluetooth devices may require pass key
input when connecting.
If this should be the case, input "0000".
Also, if connection authorization is requested,
input "authorized".
Connection is successful once "CONNECTED" is
displayed.
CONNECTED
NOTE
○ Once paired, connection will be automatically
○ No more than two devices can be paired
○ Connection with all Bluetooth devices cannot
4. Playback
NOTE
○ Some Bluetooth devices may not respond to the
○ See page 19 when recharging with USB in

USING THE TIMER FUNCTION

○ The radio turns on/off at the preset time
○ Use the radio as an alarm clock
Sleep Timer
Power can be set to automatically switch OFF after
a certain amount of time has elapsed by using the
sleep timer function.
READY
1. Press the Menu button.
2. Press the Select button and display "SLEEP".
3. Press the Enter / Information button.
4. Press the Select button to adjust the time period
5. Press the Enter / Information button.
established the next time the devices are switched
on. If the Bluetooth connection is lost, re-pair the
devices.
simultaneously.
be guaranteed. Before attempting connection,
always check for compatibility.
Make sure to lower the volume output of the
Bluetooth device before music playback.
Volume can be adjusted through the radio.
Use the Bluetooth device to select tracks .
You can also select tracks with the radio's control
buttons.
(Volume)
(Play / Stop, Search)
radio's control buttons.
"Bluetooth" mode.
SLEEP
to elapse (between "0 – 90" minutes) before the
power is switched OFF.
30 MIN
English
17