Yamaha YAS-103 Mode D'emploi page 17

6
Teach the sound bar the "Volume (+)" code of the TV's remote control.
6-1 Press VOLUME (+) on the front panel of the sound bar.
6-2 While pointing your TV's remote control at the remote control sensor, hold
down the volume (+) key for more than 1 second twice or three times.
Result Bleep/buzzer
Successfully
Once
learned
Failed to learn
* Repeat from Twice
Step 6-1.
7
Teach the sound bar the "Power" code of the TV's remote control.
7-1 Press (power) on the front panel of the sound bar.
7-2 While pointing your TV's remote control at the remote control sensor, hold
down the power key for more than 1 second twice or three times.
Result Bleep/buzzer
Successfully
Once
learned
Failed to learn
* Repeat from Twice
Step 7-1.
8
To finish the learning mode, press the LEARN key on the sound bar's
remote control.
This completes the necessary settings. Now you can operate the sound bar with
the TV's remote control's mute key, volume keys, or power key.
HINT
• The learning mode will be finished automatically if no operations are performed for 5 minutes.
• Set the TV volume to minimum. When you turn up the volume of the sound bar with the TV's remote
control, the volume of the TV may be turned up at the same time. In this case, follow Step 3 in
"Connections" (p.6) to change the TV setting.
• You can press the key on the sound bar's remote control to finish leaning mode.
Indicators
Lights up
Flash
Indicators
Lights up
Flash
Clearing all programmed functions
1
With the sound bar turned off, hold down the LEARN key on the
sound bar's remote control for more than 3 seconds. (for entering
the learning mode)
When the sound bar is in the learning mode, the indicators on the front panel flash
as shown below.
2
Hold down INPUT on the front panel of the sound bar for more than 3
seconds.
If the clearing is completed, you will hear the bleep sound three times.
3
Press the LEARN key on the sound bar's remote control.
Flashes in red (cleared)
13