Assembling The Drum Unit; Adjusting The Reefing Line Feeders - Plastimo 406-T Notice D'utilisation

5.6 - ASSEMBLING THE DRUM UNIT

- Position the sleeve or turnbuckle* on the drum (*depending on model)
- Insert coupling unit from the bottom end of the spar (ensure the hole in the coupling unit is in line with the pre-drilled
hole on the end of the base spar)
- Insert the base spar into the drum unit
- Put some silicone filler in the pre-drilled hole
- Insert the M5x12 screw
- Attach the jib reefing system to the forward mounting plate
- Lower the halyard swivel
- Tighten the backstay

5.7 - ADJUSTING THE REEFING LINE FEEDERS

5.7.1 - 406-T model
- The reefing line feeder on the 406-T model is assembled either on the right or left hand side of the drum unit, depending on which
direction you prefer to reef.
- To fasten the reefing line feeder, use the two M4x12 nuts and bolts
- The angle is adjusted by loosening the two screws that hold the chainplate.
5.7.2 - 609-T & 811-T models
- The angle of reefing line feeders on 609-T & 811-T models is adjusted by loosening the two nuts and bolts (see diagram below)
starboard assembly
- 12 -
port assembly
Screws