Opening Of Probe Directional; Measuring Position - Schiltknecht Messtechnik ThermoAir3 Mode D'emploi

ThermoAir3
32

Opening of Probe Directional

The probe is built with an eccentric shaft.
Turn right or left to secure probe.
Turn the head of the probe carefully right or left into
neutral position. Hold probe head and handle and plug in
the cable. Through pushing cable into the handle the head
of the probe is pushed out. Pull out the head carefully and
turn it left or right to secure it.
NEVER tighten it too much!
Pull down the protection cap.

Measuring Position

NEVER touch the measuring NTC!
Schiltknecht Messtechnik AG