Table des Matières
Publicité
Assembly
WARNING
Do not plug in your vacuum until you are familiar with all instructions and operating
procedures.
IMPORTANT: ALWAYS TURN UNIT OFF PRIOR TO CHARGING*
*failing to do so may result in battery not fully charging
1
2
Plug the adapter into the
Insert charging adapter
wall outlet. The power
plug into the charging
LED lights will illuminate
port on back of the unit.
when charging.
NOTE: The LED light will blink RED when charging and turn GREEN once fully
charged. After 10 minutes of being fully charged, the GREEN light will fl ash once
per minute. The adaptor may become warm during charging - this is normal.
LED Light Display Status
BATTERY STATUS
LIGHT STATUS
IN USE
In Use
Solid green light
Low Power
Blinking red light (.5 seconds)
No Power
Solid red light (3 seconds)
Brush Stall
Solid red light, then unit shuts off
CHARGING
Charging
Blinking red light (1 second)
Green light (on 10 minutes, then blinks every 1 minute)
Fully Charged
Red and green blinking light, contact Consumer Care
Charger/Battery Error
Red and green blinking light, contact Consumer Care
Battery/Motor Issue
3
8
Charge the unit
completely for 8 hours
prior to first use.
5
www.BISSELL.ca
Publicité
Table des Matières
