Stand Assembly - LEMAN MBS300 Manuel D'utilisation

Note: When Assembling this legstand Do
Not fully tighten the nuts and bolts until
the assembly is complete.

4.2 Stand Assembly

1. Locate the first leg and secure it to one
of the long top brace supports using the
nuts, bolts and washers supplied Fig.4.2
and Fig.4.2B.
2. In the same way, attach the second leg
to the brace support Fig.4.3.
3. Locate the short top brace supports
and fix the to the legs as shown Fig.4.4.
4. Continue in this way until all of the legs
and top brace supports have been fitted
Fig.4.5.
5. Locating holes a third of the way down
each leg are for securing the mid brace
supports. Fix the long mid brace supports
to the frame using the nuts, bolts and
washers Fig.4.6.
6. Finally, fit the short mid brace support
to one of the shorter sides Fig.4.7.
Note
The side with the short mid brace support
fitted will referred to as the front of the
stand. This leaves the back area free for
wheel kit operation.
Fig.4.2
Fig.4.2B
Fig.4.3
LONG TOP BRACE
SUPPORT
Fig.4.4
SHORT TOP BRACE
SUPPORTS
Fig.4.5
GB
Fig.4.6
LONG MID BRACE
SUPPORT
Fig.4.7
FRONT
6