Wheel Kit Assembly - LEMAN MBS300 Manuel D'utilisation

4.3 Wheel Kit Assembly

1. On the underside of the operating
frame, find the two raised areas on either
side. Mount the two back wheels and
secure in place using the nuts and bolts
provided Fig.4.8.
2. With the operating frame in hand,
locate the release pedal and fix it to the
operating frame Fig.4.9.
3. Take the two front wheels and mount
and secure them to the operating frame
pedal Fig.4.10.
Now slide an axle through on one of the
front legs and hook a brace support bar
on it. Place a washer on and slide a pin
throughout the axle end Fig.4.11.
4. Pass the axle through the operating
frame pedal and through the opposing
leg. Once the axle is through the
opposing leg hook the remaining brace
support bar on the axle and secure with a
washer and pin as previous Fig.34.13.
5. Now pass the remaining axle through
the rear of the stand and hook the brace
support bar with washer and pin as
previous. Fig.4.14.
6. The operating frame can now be fitted
to the axle and secured to the opposing
rear leg with the other brace support
bar, washer and pin. Ensure when this
operating frame is fitted that it sits below
the operating frame pedal Fig.4.15.
7. Once the frame is upright, the whole
assembly should fall into place. However
it will not operate correctly until the actual
bandsaw is fitted. Fig.4.16.
Fig.4.8
RAISED AREAS
RELEASE PEDAL
Fig.4.9
Fig.4.10
Fig.4.11
AXLE
WASHER
BRACE SUPPORT BAR
Fig.4.12
GB
Fig.4.13
PIN & WASHER
Fig.4.14
Fig.4.15
PIN
Fig.4.16
BRACE
SUPPORT BAR
7