Baby Unit Power Supply; Parent Unit Battery Installation; Parent Unit Power Supply - Topcom BABY VIEWER 2500 Manuel D'utilisateur

4.2

Baby unit power supply

1. Connect the small plug of the AC adaptor to the Baby unit and the other end of the
adapter cable to the electric socket (230V/50Hz).
Only use the enclosed adapter (6V DC / 1,75A).
2. Slide the Power switch (26) to the ON position. The LED (24) on top of the camera
should light up red.
Slide the Power switch (26) to the OFF position to turn off the baby unit.
4.3

Parent unit battery Installation

1. Turn the belt clip facing upwards.
2. Press the battery cover and slide it downwards.
3. Install the rechargeable battery pack (3,7V Li-ion)
following the polarity as shown. Ensure that the
metal contacts touch the contact in the unit.
Close the battery door.
4. Turn the On/Off/Volume switch (15) counter
clockwise to turn the unit on and change to the
desired audio volume.
Turn the On/Off/Volume switch (15) clockwise to
turn the parent unit off.
When the light (7) is blinking, the batteries are low
and need to be replaced.
4.4

Parent unit power supply

1. Connect the small plug of the AC adaptor to the parent unit and the other end of the
adapter cable to the electric socket (230V/50Hz)
Topcom Baby Viewer 2500
1
3
4
5