Receipt of the unit and storage
4. Receipt of the unit and storage
4.1. Reception
Keep the unit in its packaging until immediately before installation.
4.2. Equipment identification
The serial number of the equipment is its unique identifier.
The unit's serial number is marked on the specifications plate.
4.3. Transport damage
If the unit has been damaged during transport, proceed as follows:
1.
Do not proceed with the installation.
2.
Notify the distributor immediately within 5 days of receipt of the unit.
If ultimately the unit has to be returned to the manufacturer, the original packaging must be used.
4.4. Storage
Failure to follow the instructions in this section may lead to damage to the unit.
If the unit is not installed immediately after reception, the following points should be taken into account in order to
avoid damage:
•
In order to permit correct conservation of the charging stations, you must not remove them from their
original packaging until it is time to install them.
•
Deterioration of the packaging (tears, holes, etc.) prevents the charging stations from being kept in
optimum conditions before installation.
•
Keep the unit free of dirt (dust, shavings, grease, etc.) and away from rodents.
•
Keep it away from water splashes, welding sparks, etc.
•
Cover the unit with a breathable protective material in order to prevent condensation due to ambient
humidity.
•
Charging stations in storage must not be subjected to weather conditions other than those indicated
below:
Maximum relative humidity without condensation
•
It is very important to protect the unit from chemical products which can cause corrosion, as well as from
salty atmospheres.
•
Do not store the unit outdoors.
ABA2022IQM01_ - 7.55.4.413.0 - Installation and Operation Manual
ABA2022IQM01_ - 7.55.4.495.7
Environmental conditions
Minimum temperature
Minimum surrounding air temperature
Maximum surrounding air temperature
-20 ºC
-20 ºC
70 ºC
95%
Gewiss
EN
ES
FR
IT
HU
11