Publicité
Les langues disponibles
Les langues disponibles
In order to operate the tool safely, please observe the following notes:
Details of the work area
Keep the work area free of everything which could obstruct operations.
Provide for adequate illumination of the work area.
Adhere to the regulations concerning the power connection.
Lay the power cable in such a way that any damage by the drill can be
avoided.
Make sure to always keep the work area in view and to be able to reach all
necessary operating elements and safety installations.
Keep other persons away from your work area in order to avoid accidents.
Space requirements for operating and maintenance
Whenever possible, keep a free space for operating and maintenance of about 2
m around the drill position, so that you can work safely and have immediate
access in case of a failure.
At the beginning, drill very slowly, since the drill bit does only starts cutting with a
fraction of the cut surface in the material. If you drill too fast or with too much
pressure, the drill bit could get jammed.
Angled drilling
2
1
3
Operations
Drilling
Remove the screw (1), which locks the
pillar at 90°.
Loosen the two side screws (2) on the
base plate.
Loosen the clamp (3) on the support with
the help of the feed lever.
Now turn the column until the desired
angle.
Tighten the 2 screws (2) and the clamp (3)
again.
The scale on the toothed column makes
adjusting the drilling angle easier.
18
Publicité
