Publicité
Les langues disponibles
Les langues disponibles
Fixing the Core Drill Motor
Caution! When mounting the machine, risk of squashing.
Wear protective gloves!
Setting up the mounting plate
For the operation of the core drill, its operating instructions and safety
advices have to be strictly observed!
Unlocking the carriage:
1
Move the machine holder upwards until it locks
in the top position.
Use the turnstile to open the locking device of
the mounting plate.
Remove it and connect it to the core drill motor
as described subsequently.
The tool is supplied with a mounting plate,
a 10 mm fitting key and 4 Allen screws M8x20.
The mounting plate is put on in such a way with
the fitting key on the machine that the socket is
in the mounting plate on the same side as the
gear switch of the machine. Afterwards the four
screws are insert and tightened firmly.
Insert the core drill with the attached mounting
plate into the drill rig and lock it with the turnstile.
To unlock the carriage (1) pull out the lock
knob (2).
To lock the carriage move the carriage until
the locking shaft passes the hole in the
column and jumps into place.
2
Always lock the carriage when the
assembly is not in use.
17
Publicité
