Cover Plate - Makita DJV181 Manuel D'instruction

Then the tool keeps the speed until the tool is
switched off. When temperature is low and there is
less fluidity in grease, the tool may not have this
function even with the motor rotating.
ASSEMBLY
CAUTION:
Always be sure that the tool is switched off and the
•
battery cartridge is removed before carrying out
any work on the tool.
Installing or removing saw blade
CAUTION:
Always clean out all chips or foreign matter
•
adhering to the blade and/or blade holder. Failure
to do so may cause insufficient tightening of the
blade, resulting in a serious personal injury.
Do not touch the blade or the workpiece
•
immediately after
extremely hot and could burn your skin.
Tighten the saw blade securely. Failure to do so
•
may cause a serious injury.
When you remove the saw blade, be careful not to
•
hurt your fingers with the top of the blade or the
tips of workpiece.
1. Fixed position
2. Released position
013992
Before installing the blade, make sure that the blade
holder is in the released position.
To install the blade, insert the blade (teeth facing
forward) into the blade holder until it latches. The blade
holder moves to the fixed position by itself and the blade
is locked. Pull the blade lightly to make sure that the
blade does not fall off during operation.
CAUTION:
Do not open the tool opener excessively, or it may
•
cause tool damage.
operation; they may
1
013929
To remove the blade, push the tool opener forward as
far as it will go. This allows the blade to be released.
NOTE:
Occasionally lubricate the roller.
•
Hex wrench storage
be
1
013930
When not in use, store the hex wrench as shown in the
figure to keep it from being lost.

Cover plate

1
2
013876
Use the cover plate when cutting decorative veneers,
plastics, etc. It protects sensitive or delicate surfaces
from damage. Fit it on the back of the tool base.
7
1. Jig saw blade
1. Base
2. Hex wrench
2
1. Cover plate
1
2. Base
2