DOMUS LINE POLAR D-MOTION Manuel D'installation page 6

INSTALLATION MANUAL
WARNING:
Safety is guaranteed if these instructions are
followed and therefore they must be kept.
Installation may require the involvement of
qualified personnel. Before proceeding with
installation of the device ensure that the
environmental conditions are in compliance with
and suitable for the product characteristics.
Before any operation on the device disconnect
mains power.
INSTALLATION:
POLAR D-MOTION unit are recommended for
installation under wall units or shelves.
Installation can be done with the power cable to
the light positioned axially or radially with regard
to the fitting plan.
- Fix the screws (B) supplied in the holes of the
unit (A) as indicated in Fig. 1,2.
- Connect the spotlights to the adaptor and using
the extensions provided in the pack (D) following
the wiring diagram 4.
EN
- Connect the feeder plug (E) to an AC outlet 230V
50/60Hz.
POLAR D-MOTION SMDL VERSION OPERATION
(fig.3):
Switching on and off takes place by simply
approaching the sensitive IR switch (C), keeping a
steady hand, faced with the same, you can adjust
the intensity of light.
A short flash of the light indicates the
achievement of maximum brightness.
The luminosity level obtained will be saved until
the next adjustment.
The output cable of POLAR D-MOTION SMDL can
handle a load of max. 72W @ 24VDC included the
absorption of the device figure 4.
POLAR D-MOTION SMDL has a light source with 2
selectable colour temperatures. To select, proceed
as follows:
Move the hand quickly across the sensor (C) 3
times (fig.3), with the lamp on, to select the
required colour temperature.