To Stop The Product - Husqvarna WS 442 Manuel D'utilisation

To operate the remote control
The product is controlled with the remote control. The
remote control is connected to the power pack through
radio transmission. To connect the remote control, refer
to the Husqvarna power pack manual.
• Push the ON/OFF button to start and stop the
remote control.
• Longitudinal movement: The dial moves the product
along the rail.
• Arm movement: The dial moves the pivot arm to
adjust the cutting depth.
14
OK
ON/OFF
0
OK
ON/OFF
0
OK
ON/OFF
0
• To rotate the blade and to control the speed of the
product: Push and hold the return button while you
turn the dial clockwise to increase the rotation speed
of the blade.
• To stop the product: Turn the dial that controls the
rotation speed of the blade counterclockwise to its 0
position.
• If an emergency occurs, stop the product with the
stop button.
• Refer to the Husqvarna power pack manual for other
settings and functions of the remote control.

To stop the product

WARNING: Do not move the product until
the motor has stopped and the power plug is
disconnected.
1. Move the blade away from the wall. The pivot arm
points straight out from the wall.
2. Stop the blade and the water flow.
3. Push the emergency stop button on the power pack
to stop the power pack. Disconnect the power plug.
Refer to the Husqvarna power pack manual.
4. Make sure that the cut out pieces cannot fall out.
5. Move the product to an area where it can be
disassembled.
OK
ON/OFF
0
OK
ON/OFF
0
1094 - 002 - 26.09.2019