Practical Advice - Bosch GAL 18V-160 C Professional Notice Originale

12 | English
ger and a mobile device by means of Bluetooth® wireless
technology.
In conjunction with the Bluetooth® Low Energy Module, the
following connectivity functions are available for the char-
ger:
– Registration and personalisation
– Status check, output of warning messages
– General information and settings
– Management
Read the corresponding operating instructions for informa-
tion about the Bluetooth® Low Energy Module.
Errors – causes and corrective measures
Cause Corrective measures
Red temperature monitoring/error indicator (5) is flash-
ing
Charging not possible
The battery is not connected Connect battery to charger
(correctly) correctly
Battery contacts are dirty Clean battery contacts; e.g.
by connecting and discon-
necting the battery several
times. Replace battery if ne-
cessary
Battery defective Replace battery
Charger faulty Have charger checked if ne-
cessary by an authorised
after-sales service centre for
Bosch power tools
Green battery charge indicator (7) is not lighting up
Mains plug of the charger is Insert the mains plug into the
not (correctly) plugged in mains socket (completely)
Socket outlet, mains cable or Check mains voltage, have
charger defective charger checked if necessary
by an authorised after-sales
service centre for Bosch
power tools
Blue connection status indicator (4) is not lighting up
No Bluetooth® connection
Check whether the
Bluetooth® Low Energy Mod-
ule is correctly fitted and
locked in place.
Switch Bluetooth® off and on
again on your mobile device.
Check the application on
your mobile device.
Check whether Bluetooth® is
activated on your mobile
device.
Check whether your mobile
device has been overloaded.
1 609 92A 52F | (11.03.2019)
Cause Corrective measures
Reduce the distance
between the charger and
your mobile device.
Where possible, ensure that
there are no obstructions
(e.g. reinforced concrete,
metal doors) between the
charger and your mobile
device. Keep the equipment
away from any sources of
electromagnetic interference
(e.g. WiFi transmitters).

Practical advice

The charger with built-in Bluetooth® Low Energy Mod-
u
ule is fitted with a wireless interface. Local operating
restrictions, e.g. in aircraft or hospitals, must be ob-
served.
When the charger is used continuously, or for several con-
secutive charge cycles without interruption, the charger may
heat up. This is, however, harmless and does not indicate
that the charger has a technical defect.
A significantly reduced operating time after charging indic-
ates that the battery has deteriorated and must be replaced.
Battery cooling (Active Air Cooling)
The fan control unit integrated into the charger monitors the
temperature of the inserted battery. As soon as the battery
temperature is above approx. 0 °C, the battery will be cooled
by a fan. The fan generates a ventilation sound when
switched on.
If the fan does not run, it is defective or the battery temper-
ature is < 0 °C. This can increase the charging time.
Charging process
Power Boost mode
The Power Boost function charges batteries up to approx.
50% battery capacity in rapid charging mode. This means
batteries are ready for use sooner than if charged using the
standard charging mode.
With Power Boost activated, the battery is initially charged
with a high charging current, which is then gradually re-
duced.
If the battery remains in the charger, it automatically keeps
charging in conservation mode up to approx. 80% battery
capacity.
Standard charging mode
The battery is charged up to approx. 100% battery capacity.
The standard charging mode provides the best combination
of fast charging time and full battery charge. The standard
charging mode optimises the service life of the battery.
Max life time mode
The battery is charged up to approx. 80% battery capacity.
This mode charges the battery more slowly, protecting the
battery and thereby significantly prolonging its service life.
Bosch Power Tools