Suisse (Bakom); Etats Unis (Fcc) / Canada (Ic) - FEIG Electronic MWD BP-C Mode D'emploi

4.2 Suisse (BAKOM) MWD BP-C/-D
Cet appareil peut être exploité en Suisse.
4.3 Etats unis (FCC) / Canada (IC) MWD BP-U
This device complies with part 15 of the FCC Rules and with RSS-210 of Industry Canada.
Operation is subject to the following two conditions:
(1) This device may not cause harmful interference, and
(2) this device must accept any interference received, including interference that may
cause undesired operation.
Warning: Changes or modifications made to this equipment not expressly approved by
FEIG ELECTRONIC GmbH may void the FCC authorization to operate this equipment.
This equipment has been tested and found to comply with the limits for a Class B digital device,
pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection
against harmful interference in a residential installation. This equipment generates, uses and can
radiate radio frequency energy and, if not installed and used in accordance with the instructions, may
cause harmful interference to radio communications. However, there is no guarantee that interference
will not occur in a particular installation. If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment off and on, the user is
encouraged to try to correct the interference by one or more of the following measures:

Reorient or relocate the receiving antenna.

Increase the separation between the equipment and receiver.

Connect the equipment into an outlet on a circuit different from that to which the receiver is
connected.

Consult the dealer or an experienced radio/TV technician for help
FEIG ELECTRONIC GmbH
Manuel de Service
FCC ID: PJMMWDBP
IC: 6633A-MWDBP
Page 50 de 103
.
MWD BP_Handbuch_mehrsprachig_12.doc
MWD BP