Opening Service Parameters; Display During Operation; List Of The Parameters For Adjusting The Channel Functionality - FEIG Electronic MWD BP-C Mode D'emploi

9.4 Opening service parameters

To display the Service Parameter you have first to open the parameter entry as described in 9.1.
Service Parameter names are displayed with flashing character and static decimal point.
Menu navigation is conform to the navigation of standard parameter.
Symbol Key
1. F+ or F- -
10

Display during operation

The motion detector shows whether and which of the two output relays has activated on the display.
8
Fig. 8: Relay 1 active
11

List of the parameters for adjusting the channel functionality

Parameter mode must be started before setting the parameters. The channel to be parameterised is selected
according to the following table depending on the device address.
P. Setting Function
range
L 1 ... 9, Level
.
A ... F
FEIG ELECTRONIC GmbH
Manual
Key-
Description
press
Activate service parameter from
long
standard parameter menu
8
Fig. 9: Relay 2 active
Address 1 3 5 7 9 B D
Channel 1 1 3 5 7 9 B D
Channel 2 2 4 6 8 A C E
The sensitivity of the channel to be parameterised is
adjusted with this parameter.
1: low
...
F: high

The settings A to F correspond to the values 10 to 15.
Page 38 of 103
Action
Display first service parameter
name
Fig. 10: Relays 1+2 active
Description / note
MWD BP_Handbuch_mehrsprachig_12.doc
MWD BP
Display
Example
A.
8
Factory
setting
9